Wanna a stylish and cute bracelet? Make it! You will need wire and jewelry pliers. First clamp down on your wire with flat pliers, leaving at least 2 inches of excess. Bend your wire on each side of the pliers to create the base of the triangle. Bring the two ends together to create the tip of the triangle. Next, holding on to the triangle to keep the shape, curve the doubled wires to fit your wrist. Pinch the doubled wire with the pliers, and wrap the loose end around the other wire twice. Use additional pliers if needed. To create the hook, bend the other end of the wire so it’s doubled up as least 2 inches. Bend again a half an inch down to create the hook. Wrap the excess around the base of the bracelet 2 times and trim the excess. Mold to fit your wrist and enjoy!