This bracelet looks very difficult to make, but it’s not true! It’s actually just a ton of jump rings. You will need glue, 300 or so 10 mm brass jump rings, clasp, two brass barrel end caps and rope. Begin by using a little glue to add your first end cap. Let it dry for a hour. Begin threading on jump rings, as if they were beads. Continue stringing and pushing them together until you reach the end. When you get to the end, cut your rope. Fill your end cap with glue and press the end of the rope into the cap. Press firmly for 30 seconds, and then allow to dry for another hour or so. Add a clasp to one side and a jump ring to the other one. Voila! Your new bracelet is done!