Here’s one more bracelet for those who love simple and stylish jewelry. The supplies are cord, cord ends, 7mm jump rings, bolt clasps, fine wire, seed beads, strong glue, tape. Cut a length of cord the same width as your wrist. I found it easier to wrap a piece of tape around my cord to stop the ends from fraying. Apply a dab of glue to the inside of your cord end, leave to dry for a few minutes and then insert your cord. Repeat on the other side and then leave to dry. Cut a length of wire 40 – 50cm long about 10cm from the end wrap tightly around the cord a few times. Read the rest of the tutorial in the source and enjoy your bracelet!